Burley G4237/8 Manuel d'utilisateur

BURLEY G4237/8 IMAGE FLUELESS GAS HEATER INSTALLATION, SERVICING & USER INSTRUCTIONS FOR USE IN THE COUNTRIES STATED ON THE DATA PLATE AND CAR

- 10 - automatically light the pilot light, monitor its safety for about 20 seconds and then it will light the burner on high flame. To alternate b

- 11 - 10.4 FIREFRONTS The design of these affect combustion, therefore only the correct front supplied with the appliance may be fitte

- 12 - Light the fire using the method in the instructions and ensure that the pilot lights consistently and the pilot flame envelopes the thermocoup

- 13 - This is not a drying appliance. Do not place clothing or other articles, on or against it. Do not store or use flammable substances on or near

- 14 - To light the fire, first ensure the red knob is turned clockwise to OFF. Press the left hand (red) control knob for several seconds then turn

- 15 - CLEANING AND MAINTENANCE Ensure the appliance is switched off and cooled down before cleaning. The case and surround are best

- 2 - INTRODUCTION Thank you for choosing this burley product. All of our products carry a CE mark which is awarded by an independent test house (not

- 3 - 3. GENERAL REQUIREMENTS 3.1 Gas appliances must be installed in accordance with the rules in force. In the UK it is the law that all gas appl

- 4 - 4.2 Decide upon the route for the gas supply and if this is to be a concealed supply, select a suitable hole in the fire box, remov

- 5 - ensure there is no possibility of them touching the appliance. 632mm 197mm590mm Overall dimensions are as shown. Hearths - For hearth mo

- 6 - 5.3 METHOD TWO - INSET ON HEARTH OR INSET WALL MOUNTED This method allows for the fire to be inset into a wall or fireplace opening. The appl

- 7 - Fixing - The appliance should be secured to the wall using the fixing brackets on the flange of the appliance. If it is to be mounted above the

- 8 - 7.0 REASSEMBLY 7.1 To remove the glass, remove the 4 nuts in the side frames and pivoting it out from the bottom remove glass

- 9 - 9.0 TO LIGHT THE HEATER BEFORE LIGHTING. IF THE PIPES HAVE NOT BEEN PURGED OF DEBRIS, DO SO NOW BEFORE LIGHTING THE FIRE. FAILUR