Burley Cub Manuel du propriétaire télécharger pdf (Page 9)

The straps and sliding buckles sewn to the back rest of the child seat

are part of a self-adjusting system that keeps the shoulder straps at

the correct height for children of various sizes. When you tighten the

shoulder harness, the sliding buckles allow the shoulder belts to

come across the top of the child’s shoulders, creating a snug fit. At

the same time, the sliding buckles keep the straps from falling off of

the shoulders.

VI. Covers

Your Wide Screen 2-in-1 Cover™ is held in place by six snaps at the

front, rear, and top. Note that the Burley logo faces the rear.

The Wide Screen 2-in-1 Cover™ features a clear plastic flap in front.

To install, snap the mesh portion to the roll bars, then fasten the rain

flaps to the mesh portion.

When attaching the cover always start by fastening the snaps at the

top of the roll bar. Next attach the front left snap (the one closest to

the tongue). Before snapping the right front snap, tuck the front

edge of the cover under the lip of the shell. Likewise, after fastening

one of the rear snaps, tuck the rear edge of the cover below the lip

of the shell, then fasten the other rear snap.

To make your trailer more visible, clip a light into the light-holder tab

sewn on the upper part of the back of your cover. There are several

brands of inexpensive clip-on lights that will make your trailer more

visible to motorists and other cyclists.

Always use your cover to keep debris out of (and toys inside) the

trailer when it’s in tow.

Child and cyclist must wear helmets when trailering. Helmets can

prevent or significantly reduce head injury in event of accident.

No Motorized Vehicles

Your Burley-Cub is only intended for use with pedal-powered cycles;

never pull it with a motorized vehicle, as the increased acceleration

and speed could damage the trailer or cause the trailer to tip over.

Avoid Riding in Traffic

We recommend against riding in traffic. If you must ride in traffic,

do not pull your trailer on highways, busy streets, or on streets

unsafe for bicycling with children. Never assume that you will be

given the right-of-way, even if it is legally yours. Your child is a

precious load; his or her safety should not be entrusted to a car

driver whose attention or regard for bike riders is unknown. Use care

when pulling your trailer on bike routes or along bike lanes,

especially at intersections.

Ride on Clean, Paved Surfaces

Your Burley-Cub is not intended for off-road use. Towing a child off

road can be especially dangerous. Any bumps or irregularities could

cause tip over and serious injury to the bicyclist or passenger, or

damage to the trailer.

Cross over railroad tracks, curb cutouts, and road grooves at 90˚.

Riding parallel or at acute angle to such obstacles can cause a crash,

resulting in serious injury.

Riding When It’s Slippery

Be especially careful in wet, rainy, or freezing conditions. Your

ability to control and stop your bicycle when towing a trailer is

greatly impaired. In wet conditions apply your brakes periodically to

be sure the rims and brake pads are clear of water. Avoid forceful

braking which can cause dangerous skidding. Ride slowly and allow

a greater margin of safety when starting, stopping, and turning.

Do not ride on surfaces where sand, gravel, ice, oil, or other slippery

substances are present. If you must pass over slippery surfaces,

walk your bike and trailer.

Navigating Curbs, Stairs, and Escalators

Never tow your trailer over curbs; rider must dismount and walk

over any curbs. If you must traverse stairs, prevent a hazardous loss

1 2 3 4 5 6 7 8 9 10 11 12

Commentaires sur ces manuels

Pas de commentaire

Burley Cub Manuel du propriétaire Page 9

Commentaires sur ces manuels

Produits connexes et manuels pour Poussettes Burley Cub